Mini IoT Development Kit M5StickC Esp32-Pico - M5Stack
The M5Stick-C is an ESP5 powered M5Stack mini. It's a portable, easy-to-use, open source IoT development board.
(SEM IVA 27.49€)
The 8 Environment Sensors Kit, M5Stack Env Kit, includes the 8 Earth, Angle, Pir, Hub, Light, Rgb, Ir and Env Sensors.
The 8 Environment Sensors Kit, M5Stack Env Kit, includes the 8 Earth, Angle, Pir, Hub, Light, Rgb, Ir and Env Sensors.
Kit Features:
• Earth Sensor;
• Angle Sensor;
• Pir Sensor;
• Sensor Hub;
• Light Sensor;
• Rgb Sensor;
• Ir Sensor;
• Env Sensor.
Includes:
• 1x Kit 8 Environment Sensors - M5Stack Env Kit.
The M5Stick-C is an ESP5 powered M5Stack mini. It's a portable, easy-to-use, open source IoT development board.
The Hub is one of the six units of the M5GO, which can be purchased separately. This unit is used as a Grove door expander.
Attention: The Hub is just a physical expander, if you are looking for a software expander (standard protocol) like I2C, single bus, check PaHUB or PbHUB. If you connected two I2C slave devices to the HUB that share the same address, you will have problems getting I2C data from both.
This module integrates a Zhongke Weibeidou AT6558 navigation chip and a MAX2659 amplification chip used to amplify the antenna signal. The AT6558 has high performance, supports many types of satellite navigation system, capable of receiving satellite signals on 56 GNSS signal channels from 6 satellite navigation systems, joint location, navigation, weather and more. The module is able to obtain accurate information of global location, fast and precise positioning for any place.
The module can be widely used in vehicle monitoring, car navigation, on-board navigation, notebook navigation, etc. You can connect it to Port C on the M5core via the Grove cable, which is a standard UART interface.
The M5Stick-C is a Mini M5Stack, powered by ESP32, It is a portable IoT development board, easy to use and open source.
What can this do? This small block is able to realize your idea, illuminate your creativity and help with the prototyping of the IoT in a very short time. This takes away many of the pains of the development process.