Mini Fan Unit - M5Stack Fan
This module is designed with an N20 Engine and includes small propellers. This N20 motor has a supply voltage of 5V. And it has a rotation speed of 8800RPM.
(SEM IVA 2.61€)
Angle is a 10K potentiometer that can be used for continuous control, such as volume, brightness or engine speed. A potentiometer is a manually adjustable variable resistance with three terminals. Two terminals are connected to a resistive element, the third terminal is connected to an adjustable cleaner. The position of the wiper determines the output voltage. The output voltage is captured and converted by AD in ESP32 on portB.
Angle is a 10K potentiometer that can be used for continuous control, such as volume, brightness or engine speed. A potentiometer is a manually adjustable variable resistance with three terminals. Two terminals are connected to a resistive element, the third terminal is connected to an adjustable cleaner. The position of the wiper determines the output voltage. The output voltage is captured and converted by AD in ESP32 on portB.
Pinout:
• Black: Single Bus (AD, DA, GPIO);
• Red: 12C;
• Blue: Uart;
• White: Others (Depends).
Includes:
• 1x 10K Potentiometer Unit - M5Stack Angle.
JoyC is a Joystick Module designed for the M5StickC. Supports two-handed operation. The main control chip is STM32F030F4, it uses the I2C communication protocol and the M5StickC host for data transmission. The joystick range is from 0 to 200, includes 12 RGB LEDs, and the bottom of the joystick contains 16340 battery holder.
The Hub is one of the six units of the M5GO, which can be purchased separately. This unit is used as a Grove door expander.
Attention: The Hub is just a physical expander, if you are looking for a software expander (standard protocol) like I2C, single bus, check PaHUB or PbHUB. If you connected two I2C slave devices to the HUB that share the same address, you will have problems getting I2C data from both.
The Plus is an enhanced M5 Module that comes with Lipo battery (500mAh), gear potentiometer, IR transmitter, port PORT B (GPIO port) extended, port C (UART port) of the MS core and a microphone solder block. Equipped with MEGA328, it can be a major upgrade of hardware resources, adding PLUS to your work.
Communication Protocol: IIC (0x62).
This module integrates a Zhongke Weibeidou AT6558 navigation chip and a MAX2659 amplification chip used to amplify the antenna signal. The AT6558 has high performance, supports many types of satellite navigation system, capable of receiving satellite signals on 56 GNSS signal channels from 6 satellite navigation systems, joint location, navigation, weather and more. The module is able to obtain accurate information of global location, fast and precise positioning for any place.
The module can be widely used in vehicle monitoring, car navigation, on-board navigation, notebook navigation, etc. You can connect it to Port C on the M5core via the Grove cable, which is a standard UART interface.