Mini IoT Development Kit M5StickC Esp32-Pico - M5Stack
The M5Stick-C is an ESP5 powered M5Stack mini. It's a portable, easy-to-use, open source IoT development board.
(SEM IVA 2.99€)
The Hub is one of the six units of the M5GO, which can be purchased separately. This unit is used as a Grove door expander.
Attention: The Hub is just a physical expander, if you are looking for a software expander (standard protocol) like I2C, single bus, check PaHUB or PbHUB. If you connected two I2C slave devices to the HUB that share the same address, you will have problems getting I2C data from both.
The Hub is one of the six units of the M5GO, which can be purchased separately. This unit is used as a Grove door expander.
Attention: The Hub is just a physical expander, if you are looking for a software expander (standard protocol) like I2C, single bus, check PaHUB or PbHUB. If you connected two I2C slave devices to the HUB that share the same address, you will have problems getting I2C data from both.
Characteristics:
• Grove Expander;
• Two Lego Compatible Sockets.
Includes:
• 1x Grove 3-Port Hub Unit - M5Stack Hub.
The MFRC522 operates in the frequency range of 13.56 MHz and uses the principle of modulation and demodulation to interact with the RF proximity card. This unit can perform the function of the card reading and writing device, to identify and record various information on the card, to encode and authorize an RF card.
IR is an Infrared Photoelectric Sensor. The infrared remote control is widely used in consumer electronics; it can be used to operate devices such as televisions, DVD players or other household appliances within a short distance. Since this unit comes with a transmitter and receiver, you can practice not only IR encoding, but also IR decoding.
BugC is a programmable robot base compatible with the M5StickC. It has four DC motors, two RGB LEDs, battery holder and a switch. The BugC base must be used in conjunction with the M5StickC controller. The base comes with a STM32F030F4 Microcontroller, which controls all motors and LEDs, and is controlled by the I2C protocol by M5StickC, which is on top of the base.
The Plus is an enhanced M5 Module that comes with Lipo battery (500mAh), gear potentiometer, IR transmitter, port PORT B (GPIO port) extended, port C (UART port) of the MS core and a microphone solder block. Equipped with MEGA328, it can be a major upgrade of hardware resources, adding PLUS to your work.
Communication Protocol: IIC (0x62).