The BM2450kV XXD Brushless Motor for Quadcopter RC 2450kV Airplane with Maximum Efficiency Current from 4A to 10A and Capacity of 12A.
The 2 Mini Engine Kit (CW+CCW) with Propellers and 4 Axles.
A Machifit JT80SL DC 3-6V Mini Submersible Water Pump . When Dipping the Pump in the Water, the Water Level is Higher than the Pump. The Low Water Level will make the Temperature Very High, so the Pump Noise will be Great. To keep the water clean, so as not to block the pump, it must be cleaned regularly to keep it clean.
A 3CH ESC MCPM Multifunction Digital Analog Servo Tester that uses Aluminum Alloy Housing. You can Test Analog and Digital Servos. You can Control the ESC (Continuous Motor Speed Test) and you can Test Three Servos Simultaneously if they are Synchronized.
Fan 12V 120x120x25MM
Stepper Motor: Bipolar, 200 Steps/Rev, 20×30mm, 3.9V, 0.6 A/Phase
50:1 Metal Gearmotor 37Dx70L mm with 64 CPR Encoder
Motor DC 6V DC 250MA 14500RPM 2,5 ~ 6V DC
Micro Metal Gearmotor 0.9A - 100:1
H-bridge Stepper Motor Dual DC Motor Driver L9110S
Pololu Carrier for MQ
Micro Metal Gearmotor 0.9A - 50:1
Wio Link - IoT Controller
JST RCY Plug with 10cm Leads, Female
This compact bracket enables convenient mounting of popular, Sanyo-style micro metal gearmotors. The black plastic bracket encloses the otherwise exposed gears, and the mounting tabs capture the nuts for easy installation. The brackets are sold in pairs, and each bracket comes with two #2 screws and two nuts.
Ventilador 12V 40x40x10mm.
This board provides a simple way to add motor driving capability to a BBC micro:bit. It allows two motors to be driven with full forward, reverse & stop control. It has terminal blocks to connect four input devices and a regulated 3V supply is fed in to the 80 way connector to power the inserted BBC micro:bit.
The motor shield is based on the L298 , it is a double complete bridge driver designed to drive inductive loads, such as relays, solenoids, DC and stepper motors.
O SparkFun Pi Servo HAT permite que o Raspberry Pi controle até 16 servos motores de maneira directa e descomplicada por meio de uma conexão I2C.
The SW01 drive kit consists of two standard servos , modified from the factory for continuous rotation and two wheels.
This is a DC motor with and metal gear with encoder . It is a 6V engine with a 20: 1 metal gearbox and an integrated quadrature encoder that offers a resolution of 11 counts per revolution.
This module is based on the popular L298N H Bridge DC Motor Driver . The circuit will allow you to easily and independently control two motors up to 2A each in both directions.
These engines are moto-reducers are the same ones used in the Magician Chassis and Kit Redbot and offer a cheap and easy to use configuration to get your wheels spinning. Because these gear motors are at a right angle, you will also be able to monitor and control your wheel rotation!
Full size 2 wheels package with rubber base - 125 mm in diameter and 60 mm wide .
Make a project with an aerial propeller, a cooling system or a rotating machine with this small fan module. The module includes a propeller, 15,000rpm engine and cable.
The metal turbo gear worm engine uses a metal gearbox for durability and a high torque output. Due to the special mechanical structure of the auger, the motor output shaft is self-locking and cannot be rotated.