The HC-12 433MHz Transceiver is a wireless communication Module, which is based on the RF SI4463 chip, has a built-in microcontroller and can be configured by AT commands, the maximum output power is 100mW (20dBm) and the receiver sensitivity differs from: 117dBm to -100dBm, depending on the transmission speed. Accepts 3.2V - 5.5V and can be used with 3.3V and 5V UART voltage devices.

An RFID Reader with PIN Code , from Orno.

RF Link Transmissor - 434MHz

XBee 6.3mW Wire Antenna - Series 2C ZigBee Mesh

XBee Pro 63mW PCB Antena - Series 2B (ZigBee Mesh)

Módulo 433MHZ LORA com alcance 3000m.

This is the ID-20LA , very simple to use the RFID Innovations ID reader module. With a built-in antenna , the only protrusion is the 2mm pin spacer . Just power the module, use a 125kHz card , and get a serial chain output that contains the card's unique identification.

This is an os card for our RFID readers . The SparkFun L eid RFID Breakout converts the 2mm pins to the breadboard in a friendly 0.1 "headers. With this ability the ID-3LA, ID-12LA, and ID-20LA you can weld the reader directly to the header or use the 2 mm connectors

The RFID Smart Lock can provide good security protection for your personal items, in addition to protecting your privacy. It can also improve the safety of children at home, prevent them from being free to open drawers or cabinet doors.

Each Card pre-programmed with a unique identification number, printed on the card. The Identification Card is suitable for the 125KHZ Card Reader and the Reading Distance is 0cm to 10cm. Used in Identification, Financial Identification, Access Control Systems, Low Frequency Identification Cards and so on. Read-only, not HID card.

This is the FeatherWing Adalogger: it adds a real-time clock with battery and micro SD card storage to any Feather mainboard. Using the Headers, you can connect a FeatherWing to the top of your board and let the board fly!

The MFRC522 operates in the frequency range of 13.56 MHz and uses the principle of modulation and demodulation to interact with the RF proximity card. This unit can perform the function of the card reading and writing device, to identify and record various information on the card, to encode and authorize an RF card.

ITDB031 is a serial port BLE Module. It is based on TI's CC2541 BLE chip. With it, you can transfer data wirelessly and do remote control. It supports central and peripheral modes. And it supports remote control for the other side that is connected. You can also support custom commands when you combine it with other devices. BLE Bee is compatible with XBee. You can simply connect it to XBee.

Note: The serial interface is 3.3V, not the typical 5V, as with many Arduino boards.

Stem Shield for your Arduino, the Velleman.

When you assign a high level to the module pin, the electro magnet can suck magnetically conductive objects. Otherwise, it will release the object.

An electro magnet is a type of magnet in which the magnetic field is produced by electric current. An electric current flowing in a wire creates a magnetic field around the wire, due to the Ampere Law. To focus the magnetic field on an electro magnet, the wire is wound into a coil with many twists of wire side by side. The Magnetic Field of All Twists of the Wire passes through the Coil Center, creating a Strong Magnetic Field there.

It's Easy to Use to Learn the Electro Magnet Principle.

The Module KA2284 is a Battery, Power and Audio Level Indicator.

In/Out Shield for your Arduino, Velleman.

Special for garden lighting, this Transmitter and Receiver Kit with 2 Channels allows you to switch the lighting of your Garden in 2 different zones with the commands on and off.