This is the ID-20LA , very simple to use the RFID Innovations ID reader module. With a built-in antenna , the only protrusion is the 2mm pin spacer . Just power the module, use a 125kHz card , and get a serial chain output that contains the card's unique identification.

This is an os card for our RFID readers . The SparkFun L eid RFID Breakout converts the 2mm pins to the breadboard in a friendly 0.1 "headers. With this ability the ID-3LA, ID-12LA, and ID-20LA you can weld the reader directly to the header or use the 2 mm connectors

The kit does not require any soldering and is recommended for anyone with a drive to learn more about Blynk and its uses. So if you are looking for a new challenge or a way to get in on the IoT craze, check out the SparkFun IoT Starter Kit with Blynk Board!