Each Card pre-programmed with a unique identification number, printed on the card. The Identification Card is suitable for the 125KHZ Card Reader and the Reading Distance is 0cm to 10cm. Used in Identification, Financial Identification, Access Control Systems, Low Frequency Identification Cards and so on. Read-only, not HID card.

This is an os card for our RFID readers . The SparkFun L eid RFID Breakout converts the 2mm pins to the breadboard in a friendly 0.1 "headers. With this ability the ID-3LA, ID-12LA, and ID-20LA you can weld the reader directly to the header or use the 2 mm connectors

The NRF24L01+ Module is an excellent wireless communication option between devices like the Arduino.

RF Link Transmissor - 434MHz

2.4 GHz 3dBi foldable antenna with reverse bias - SMA RF connector. Perfect for prototyping with RF ICs and Xbee modules. 50 ohm impedance. 10.16cm in length.

These wireless receivers work with our 434MHz transmitters. They can easily fit on a breadboard and work well with microcontrollers to create a very simple wireless data connection. Since these are just the receivers, they will only work one way data communication, you would need two pairs to act as a transmitter / receiver pair.

This is a fantastic find for SFE. A small, high-quality, quad-band, standard SMA terminated, cellular antenna.

infrared devices are widely used and often for remotely controlled devices . With this IR receiver, your Arduino project is now able to receive commands from any IR remote controller.

2.4GHz SMA - 3dBi antenna

3dBi GPS antenna SMA connector