Carbon monoxide detector with alarm - orno

This Disk Load Cell (sometimes called the Strain Gauge) can translate up to 200kg of Pressure(Force) into a Electrical Signal. Each Load Cell is capable of measuring the electrical resistance that changes in response and proportional to the voltage (eg pressure or force) applied to the disk. With this gauge, you'll be able to tell how heavy an object is, if an object's weight changes over time, or if you simply need to feel the presence of an object by measuring the tension or load applied to a surface.

This is a small Force Sensitive Resistor . It has an Active Detection Area of 0.16 "(4mm) in Diameter. This FSR from Interlink Electronics varies its Resistance depending on how much Pressure is being applied to the Detection Area. The stronger the Force, the lower the Resistance. When there is no Pressure Applied to the FSR, its Resistance will be greater than 1MΩ, with the Total Pressure applied to the Resistance it will be 2.5kΩ Two Pins extend from the Bottom of the Sensor, making it friendly to the Breadboard. are simple to set up and great for detecting pressure.

Pololu Carrier for MQ Gas Sensors Bare PCB Only

Piezo Vibration Sensor - Large

Analog Hydrogen Gas Sensor MQ8

Grove - Air quality sensor V1.3

GY-80 BMP085 Magnetic Field, Acceleration, Gyroscope

This semiconductor gas sensor detects the presence of combustible gas and smoke at concentrations from 300 to 10,000 ppm. The sensor’s simple analog voltage interface requires only one analog input pin from your microcontroller.

This sensor has a piezoelectric transducer that responds to voltage changes, generating a measurable change in output voltage that is proportional to the force of vibration . In this way, it is possible to know the vibration force , as opposed to the digital vibration sensor that only counts time.

This Load Sensor, sometimes called a strain gauge, is the same one found in digital bathroom scales. This sensor can measure up to about 110 pounds.