This Disk Load Cell (sometimes called the Strain Gauge) can translate up to 200kg of Pressure(Force) into a Electrical Signal. Each Load Cell is capable of measuring the electrical resistance that changes in response and proportional to the voltage (eg pressure or force) applied to the disk. With this gauge, you'll be able to tell how heavy an object is, if an object's weight changes over time, or if you simply need to feel the presence of an object by measuring the tension or load applied to a surface.

Electrolytic Condenser for use in rectifier circuits, power supplies and general electronic circuits. When connecting the Electrolytic Condenser, check the polarity of the terminals to prevent component damage. The larger terminal corresponds to the positive, and the smallest to the negative.

This is a small Force Sensitive Resistor . It has an Active Detection Area of 0.16 "(4mm) in Diameter. This FSR from Interlink Electronics varies its Resistance depending on how much Pressure is being applied to the Detection Area. The stronger the Force, the lower the Resistance. When there is no Pressure Applied to the FSR, its Resistance will be greater than 1MΩ, with the Total Pressure applied to the Resistance it will be 2.5kΩ Two Pins extend from the Bottom of the Sensor, making it friendly to the Breadboard. are simple to set up and great for detecting pressure.

Piezo Vibration Sensor - Large

GY-80 BMP085 Magnetic Field, Acceleration, Gyroscope

This sensor has a piezoelectric transducer that responds to voltage changes, generating a measurable change in output voltage that is proportional to the force of vibration . In this way, it is possible to know the vibration force , as opposed to the digital vibration sensor that only counts time.

This LED Matrix 24 × 8 display is specially designed for the FireBeetle series. It supports low power mode and scroll display. With HT1632C high-performance LED driver chip , each led has an independent register, which facilitates separate driving. Integrates a 256KHz RC clock, only 5uA in low power mode, supports 16-scale PWM brightness adjustment. This product also works with another Arduino microcontroller like Arduino UNO (same as DFRduino UNO).

The MAX30100 is a complete solution of Pulse Oximetry System and Heart Rate Sensor. The MAX30100 provides a very small solution without sacrificing optical or electrical performance.

Finger is a fingerprint sensor that makes fingerprint verification super simple.

The Uart protocol, compact size and ultra low power consumption make the use of MSStack series products very attractive. It performs fast fingerprint matching with the highest level of security and the ideal convenience of the user. You can program to set the level of comparison of the fingerprint recognition and the different security level. If you've ever thought about protecting your project with biometrics, don't forget to include this MSunit Finger.

This unit communicates with the M5Core by UART protocol connected via PORTC.

This Load Sensor, sometimes called a strain gauge, is the same one found in digital bathroom scales. This sensor can measure up to about 110 pounds.