Analog Hydrogen Gas Sensor MQ8

Analog turbidity sensor for Arduino

This module is based on the popular L298N H Bridge DC Motor Driver . The circuit will allow you to easily and independently control two motors up to 2A each in both directions.

Load Cell - 50Kg

SparkFun RGB and Gesture Sensor - APDS-9960

O sensor de fluxo de água consiste em um corpo de válvula de plástico, um rotor de água e um sensor de efeito hall. Quando a água flui através do rotor, o rotor rola.

VL6180X Time-of-Flight Distance Sensor Carrier with Voltage Regulator

Bi-directional Logic Level Converter 4-channel by I2C BSS138

The motor shield is based on the L298 , it is a double complete bridge driver designed to drive inductive loads, such as relays, solenoids, DC and stepper motors. 

Adafruit Small 1.2 8x8 LED Matrix w/I2C Backpack - Yellow-Green

This is the FeatherWing Adalogger: it adds a real-time clock with battery and micro SD card storage to any Feather mainboard. Using the Headers, you can connect a FeatherWing to the top of your board and let the board fly!

A Whadda Universal Temperature Sensor Mounting Kit, used for measuring indoor and outdoor temperatures, controlling the rise/fall of temperature in homes, equipment, control of temperatures in some processes, visualization of the temperature on your website, control of the temperature of your pool, etc.

Gravity: IO Expansion Shield for Arduino V7.1

The HC-12 433MHz Transceiver is a wireless communication Module, which is based on the RF SI4463 chip, has a built-in microcontroller and can be configured by AT commands, the maximum output power is 100mW (20dBm) and the receiver sensitivity differs from: 117dBm to -100dBm, depending on the transmission speed. Accepts 3.2V - 5.5V and can be used with 3.3V and 5V UART voltage devices.

This version of the Ethernet Shield is not only compatible with Mega 1280 and 2560, but also provides a Micro SD card slot for read / write

This is the Infrared Proximity Sensor made by Sharp.

This Shuck Socket it is easy to use and to install.

Life has its ups and downs, so why not measure them? The MPL3115A2 is a MEMS pressure sensor that provides Altitude data to within 30cm (with oversampling enabled).

Joystick red by Joy-D.

BTBee Pro is a Bluetooth serial port module that can be compatible with shields that have XBee socket.