A small Audio Speaker that is ideal for radio and amplifier projects.

A small Audio Speaker that is ideal for radio and amplifier projects.

The Grove - Speaker is a module consisting of power amplification and voice outputs. The volume can be adjusted by the integrated potentiometer . With input frequencies at different, the speaker generates different tones. Encoding the music in Arduino, make your own music box yourself!

SparkFun RGB and Gesture Sensor - APDS-9960

SparkFun OpenScale

SparkFun OpenLog

SparkFun Luminosity Sensor - TSL2561

SparkFun humidity sensor - HIH-4030

The Si7021 is a low-cost, easy-to-use, highly accurate, digital humidity and temperature sensor. 

Life has its ups and downs, so why not measure them? The MPL3115A2 is a MEMS pressure sensor that provides Altitude data to within 30cm (with oversampling enabled).

The purpose of this sensor is to measure the sound intensity of the surrounding environment.

Solid State Relay - 8 Channels

The Earth Unit is a Sensor for measuring Humidity in Soil or Similar Materials. The Soil Moisture Sensor is quite simple to use. The two large stake-type sensors act as probes for the sensor, acting together as a variable resistance. The higher the moisture in the soil, the better the conductivity between the two, so that the sensor results in less resistance and higher GIS output.

You can read the moisture in the soil through ADC. Within this unit, there is an extra potentiometer to change the measurement range.

This package includes a Sensor of Level of Water and a Sensor of Humidity from Solo. If the plates have water covering the sensor components, an analog value will be available on the "SIG" connection. The Sensor of Level of Water can detect up to 4cm of water. This way, you can check if your aquarium, or your pet's water bowl, still has enough water. You can use the Sensor of Moisture of the Soil to check your plant's soil or growing environment, for example.

The motor shield is based on the L298 , it is a double complete bridge driver designed to drive inductive loads, such as relays, solenoids, DC and stepper motors. 

The W5500 Ethernet Shield v1.0 can be used to provide your projects with internet connectivity.W5500 enables users to have the Internet connectivity in their applications just by using the single chip in which TCP/IP stack, 10/100 Ethernet MAC and PHY embedded. The shield also have two Grove connectors and a microSD card socket to support projects which require storing large amounts of data from Grove sensor. The RJ45 port (Where the Ethernet cable is connected to) is low enough to allow you to stack more shields on top of this one if needed.

This relay shield is capable of controlling 4 relays . The maximum switching power can be 360VA / 90W . It can be controlled directly by the Arduino by means of digital IOs digital with external power of 9v . With integrated xbee socket and APC220 socket, it can be controlled wirelessly via Xbee / bluetooth / APC220 . Make it an ideal solution for home automation and robotics.

The Grove – UV Sensor is used for detecting the intensity of incident ultraviolet(UV) radiation. This form of electromagnetic radiation has shorter wavelengths than visible radiation. It is based on the sensor GUVA-S12D.It has a wide spectral range of 200nm-400nm. The module will output electrical signal which is varied with the change of the UV intensity. UV sensors are used for determining exposure to ultraviolet radiation in laboratory or environmental settings.

Sensor Temperatura PT-100