Color is a Light to Digital Color Converter with IR Filter. The TCS3472 Device provides a digital red, green, blue (RGB) return and sharp light detection values. An infrared blocking filter, integrated in the chip and located in the color-sensing photodiodes, minimizes the infrared spectral component of the received light and allows color measurements to be made accurately.

This unit communicates with the M5Core through the Grove (I2C) port. The address is 0x29.

Crash sensor(Left)

This version of the Ethernet Shield is not only compatible with Mega 1280 and 2560, but also provides a Micro SD card slot for read / write

DHT22 is a digital capacitive humidity sensor and humidity module is one that contains the compound has been calibrated with digital signal output from the temperature and humidity sensors . < / p>

This Flame Sensor is sensitive to the flame, but also can detect ordinary light. Usually used as a flame alarm. 

infrared devices are widely used and often for remotely controlled devices . With this IR receiver, your Arduino project is now able to receive commands from any IR remote controller.

This sensor has a piezoelectric transducer that responds to voltage changes, generating a measurable change in output voltage that is proportional to the force of vibration . In this way, it is possible to know the vibration force , as opposed to the digital vibration sensor that only counts time.

Digital Push Button (Green)

Digital Push Button (White)

This module is based on the popular L298N H Bridge DC Motor Driver . The circuit will allow you to easily and independently control two motors up to 2A each in both directions.

This DTMF Shield is a Dual-tone multi-frequency signaling module decoder for Arduino With it's audio connector you can decode the crazy funny noises common phones make.

Monitor the consumption of any appliance, electrical circuit or office equipment (lighting, sockets, security systems, heaters, air conditioning, etc.) individually with this compact device that works via Wifi so you can monitor everything through your smartphone.

A Starter Kit Educational DIY Smart Home with the Arduino UNO R3, in a Component Box with a Protective Cover, with a Sensor of PIR Movements, a Bluetooth V4.0 Module, a Water Sensor, a Relay Module, a Humidity Sensor, an LCD1602 Display, even a Screwdriver, a Set that in total consists of about 110 pieces.

Electrolytic Condenser for use in rectifier circuits, power supplies and general electronic circuits. When connecting the Electrolytic Condenser, check the polarity of the terminals to prevent component damage. The larger terminal corresponds to the positive, and the smallest to the negative.