LiPower - Boost Converter
The LiPower board is based on the incredibly versatile TPS61200 boost converter.
(SEM IVA 10.30€)
This is a very simple breadboard power supply kit that takes power from a DC wall wart and outputs a selectable 5V or 3.3V regulated voltage.
This is a very simple breadboard power supply kit that takes power from a DC wall wart and outputs a selectable 5V or 3.3V regulated voltage. The .1" headers are mounted on the bottom of the PCB for simple insertion into a breadboard. Pins labeled VCC and GND plug directly into the power lines. The lone pair of pins have no electrical connection but help support the PCB. There are two pins available within the barrel jack footprint. Any stripped +/- DC supply can be connected instead of the barrel connector. Board has both an On/Off switch and a voltage select switch (3.3V/5V). Comes as a bag of parts kit and is easily assembled if you can follow the silkscreen indicators and have beginning experience with a soldering iron. You will need to read the resistor bands or use a multimeter to determine the resistor sizes. Dimensions: 1.25x1.25" Includes: - DC Barrel Connector (2.1mm center positive)- TO-220 Voltage Regulator (LM317 1.5A max current)- 1N4004 Reverse Protection Diode- 100uF 25V Capacitor- 10uF 25V Capacitor- 0.1uF 50V Capacitor- Red Power LED - High Brightness- 2 x SPDT Slide Switch- 4 x 0.1" Header Pins- 2 x 330 Resistor 1/6W- 390 Resistor 1/6W- 240 Resistor 1/6W- Bare PCB with Silkscreen Indicators- PTC resettable fuse Documents: - Schematic- Guide PRT-00114
The LiPower board is based on the incredibly versatile TPS61200 boost converter.
12V to 230V converter with 130W of power.
Platinet's Power bank for charging electronic devices such as smartphones, mobile phones, MP3/MP4, GPS and other devices powered by the voltage of 5V.