Mini IoT Development Kit M5StickC Esp32-Pico - M5Stack
The M5Stick-C is an ESP5 powered M5Stack mini. It's a portable, easy-to-use, open source IoT development board.
(SEM IVA 54.00€)
local_shippingPORTES DE ENVIO GRÁTIS
The RoverC is a programmable omnidirectional mobile robot base compatible with the M5StickC and can be started with the insertion of the M5StickC. The main controller of the base is the microcontroller stm32f030f4. The base comes with N20 worm gear motors, which are directly driven by a four-channel motor driver. These motors are connected to the mechanum wheels, which can move in all directions. In addition, two Grove-compatible I2C ports are provided to facilitate expansion to other modules.
The RoverC is a programmable omnidirectional mobile robot base compatible with the M5StickC and can be started with the insertion of the M5StickC. The main controller of the base is the microcontroller stm32f030f4. The base comes with N20 worm gear motors, which are directly driven by a four-channel motor driver. These motors are connected to the mechanum wheels, which can move in all directions. In addition, two Grove-compatible I2C ports are provided to facilitate expansion to other modules.
The base is also compatible with Lego blocks and can be expanded in structure. A 16340 battery is installed at the rear of the base to meet the car's power and resistance requirements and can be controlled by an independent switch.
Characteristics:
• I2C 0x38 address;
• Remote Control;
• Programmable;
• Compatible with Lego;
• Extra Grove Doors for Expansion;
• Equipped with 16340 Battery Holder;
• Flexible movement in all directions;
• Dimensions: 75mm x 75mm x 55mm.
Note: M5StickC Not Included.
Includes:
• 1x Programmable Robot RoverC for M5StickC - M5Stack RoverC.
The M5Stick-C is an ESP5 powered M5Stack mini. It's a portable, easy-to-use, open source IoT development board.
The MFRC522 operates in the frequency range of 13.56 MHz and uses the principle of modulation and demodulation to interact with the RF proximity card. This unit can perform the function of the card reading and writing device, to identify and record various information on the card, to encode and authorize an RF card.
The Hub is one of the six units of the M5GO, which can be purchased separately. This unit is used as a Grove door expander.
Attention: The Hub is just a physical expander, if you are looking for a software expander (standard protocol) like I2C, single bus, check PaHUB or PbHUB. If you connected two I2C slave devices to the HUB that share the same address, you will have problems getting I2C data from both.
This module has two buttons of different colors. They share exactly the same mechanism, the status of the button can be detected by the status of the input pin, just capture the high / low electrical level.
This unit communicates with the M5Core through the Grove B port.