Mini IoT Development Kit M5StickC Esp32-Pico - M5Stack
The M5Stick-C is an ESP5 powered M5Stack mini. It's a portable, easy-to-use, open source IoT development board.
(SEM IVA 15.71€)
BugC is a programmable robot base compatible with the M5StickC. It has four DC motors, two RGB LEDs, battery holder and a switch. The BugC base must be used in conjunction with the M5StickC controller. The base comes with a STM32F030F4 Microcontroller, which controls all motors and LEDs, and is controlled by the I2C protocol by M5StickC, which is on top of the base.
BugC is a programmable robot base compatible with the M5StickC. It has four DC motors, two RGB LEDs, battery holder and a switch. The BugC base must be used in conjunction with the M5StickC controller. The base comes with a STM32F030F4 Microcontroller, which controls all motors and LEDs, and is controlled by the I2C protocol by M5StickC, which is on top of the base.
Characteristics:
• Programmable;
• 4 Engines;
• 2xRGB LEDs;
• Simple and compact design;
• Equipped with a Battery Holder;
• Flexible movement in all directions;
• Dimensions: 55mmx40mmx25mm.
Note: M5StickC Not Included.
Includes:
• 1x BugC;
• 1x Battery 16340 750mAh.
Color is a Light to Digital Color Converter with IR Filter. The TCS3472 Device provides a digital red, green, blue (RGB) return and sharp light detection values. An infrared blocking filter, integrated in the chip and located in the color-sensing photodiodes, minimizes the infrared spectral component of the received light and allows color measurements to be made accurately.
This unit communicates with the M5Core through the Grove (I2C) port. The address is 0x29.
Finger is a fingerprint sensor that makes fingerprint verification super simple.
The Uart protocol, compact size and ultra low power consumption make the use of MSStack series products very attractive. It performs fast fingerprint matching with the highest level of security and the ideal convenience of the user. You can program to set the level of comparison of the fingerprint recognition and the different security level. If you've ever thought about protecting your project with biometrics, don't forget to include this MSunit Finger.
This unit communicates with the M5Core by UART protocol connected via PORTC.
The M5Stick-C is an ESP5 powered M5Stack mini. It's a portable, easy-to-use, open source IoT development board.
The Hub is one of the six units of the M5GO, which can be purchased separately. This unit is used as a Grove door expander.
Attention: The Hub is just a physical expander, if you are looking for a software expander (standard protocol) like I2C, single bus, check PaHUB or PbHUB. If you connected two I2C slave devices to the HUB that share the same address, you will have problems getting I2C data from both.