This site uses cookies to improve your experience. By navigating this site, you consent to the use of cookies. Learn more about our cookies.

New

Voltage to Analog Current Converter 4 ~ 20mA

€8.76

(SEM IVA 7.12€)

i0598

Voltage to Analog Current Converter 4 ~ 20mA

Quantity
In Stock

Voltage to Analog Current Converter 4 ~ 20mA

This current-to-voltage module can linearly convert 0~25mA current signals into 0~3V voltage signals. Industrial sensors or devices usually have the current signal output of 4~20 mA. With this current-to-voltage module, your main control board can easily attain the current signals input from industrial sensors or devices.

Normally, current signals lower than 4mA can be used for fault diagnosis, and current signals higher than 20mA can be used for overrun detection. Therefore, this module is specially designed with a wide detection range from 0 to 25mA, and compatible with fault detection, overrun detection applications.

This module employs 0.1% high precision sense resistor and ultra-low noise rail-to-rail zero-drift op amp, high accuracy, no need to calibration, so it is convenient to use. 3.3V~5.5V wide voltage power supply, 0~3V voltage signal output, which are compatible with more main control boards, adapt to more applications. 

SEN0262_app1_black.jpg


NOTE: For higher accuracy, it is recommended to measure with 12 or more bit ADC!

FEATURES

Support wide voltage of 3.3~5.5VDeploy 0.1% high precision sense resistor and ultra low noise rail-to-rail zero-drift op amp, high accuracy, and no need to calibrationWide measurement range up to 0~25mA, which is compatible with fault diagnosis, overrun detection applications

SPECIFICATION

Supply Voltage: 3.3~5.5VDetection Range: 0~25mA DCMeasurement Accuracy: ±0.5% F.S. @ 16-bit ADC, ±2% F.S. @ 10-bit ADCTermination Resistance: 120ΩConnector Type: PH2.0-3PProduct Size: 30mm x 22mm 1.18inch x 0.87inch 

DOCUMENTS

Product wikiMore Documents

SHIPPING LIST

Analog Current to Voltage Converter     x1Digital Sensor Cable 3pin        x1

Includes:

• 1x Conversor de Tensão para Corrente Analógica 4~20mA

No customer reviews for the moment.

Related Products

Driver for 2 Motors 2 x 15A DC - DFRobot

0 Review(s) 
In Stock
Price €44.90

This DC motor driver can be used on 4WD mobile robot platforms, combat robots, smart car competition, drive pumps, electric fans, transporters, etc ...

I2C LIS2DH Triple Axis Accelerometer - DFRobot

0 Review(s) 
In Stock
Price €8.36

DFRobot features the ultra-low power triple-axis Arduino accelerometer ! This device is based on a MEMS LIS2DH chip solution and features high performance ultra-low power consumption mode . The module is equipped with a Gravity I2C interface for easy plug and play integration into your projects. The integrated LDO power management chip offers a wide range of input voltages, from 3.3 to 5V . The I2C level conversion on-board also makes it compatible with 3.3 and 5V devices.

Turbocharger Gear Motor 12v 160RPM - DFRobot

0 Review(s) 
There are not enough products in stock
Price €23.37

The metal turbo gear worm engine uses a metal gearbox for durability and a high torque output. Due to the special mechanical structure of the auger, the motor output shaft is self-locking and cannot be rotated.

New Order